LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 585 (Brake System) >> Removal And Installation >> Brake Pedal >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove instrument lower panel LH. Refer to Removal and Installation .
  2. Remove sonar control unit (if equipped). Refer to Removal and Installation .
  3. Disconnect the harness connectors from the stop lamp switch and brake pedal position switch.
  4. Disconnect the harness connector from the brake stroke sensor (if equipped).
  5. Remove wire harness clips from brake pedal assembly.
  6. Remove snap pin and clevis pin from clevis of brake booster.
  7. Remove the brake pedal assembly.
    CAUTION: Support the brake booster and master cylinder to prevent contact with other components.
scientia non olet · About LEMON Manuals