LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 585 (Brake System) >> Removal And Installation >> Brake Booster >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove instrument lower panel LH. Refer to Removal and Installation .
  2. Remove harness clip.
  3. Remove the snap pin (1) and clevis pin (2) from the brake pedal.
    GNSJPFIA0019Z-019Courtesy of NISSAN NORTH AMERICA, INC.
  4. Remove the cowl top extension. Refer to Removal and Installation .
  5. Disconnect vacuum hose from brake booster. Refer to Exploded View .
  6. Remove master cylinder assembly. Refer to Removal and Installation .
  7. Disconnect the harness connector from the booster pressure sensor.
  8. Disconnect the Intelligent Key system warning buzzer from the strut tower and place aside.
  9. Remove the four nuts on the brake booster and brake pedal assembly.
    CAUTION: Secure the brake booster to avoid damage to components.
  10. Remove the brake booster from the dash panel on the engine room side.
    CAUTION: Do not deform or bend the brake pipes.
scientia non olet · About LEMON Manuals