LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 585 (Brake System) >> Removal And Installation >> Brake Booster >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen lock nut (1) and adjust input rod (2) to the specified length (B).
    GNSJPFIA0020Z-020Courtesy of NISSAN NORTH AMERICA, INC.

    Length (B)

    : Refer to Brake Booster .
  2. After adjustment, temporarily tighten lock nut to install booster assembly.
  3. Install a new gasket between the brake booster and dash panel.
    CAUTION: Do not reuse the gasket.
  4. Install the brake booster to the dash panel from the engine room side.
    CAUTION: Do not damage brake booster stud bolt threads during installation.
  5. Install the four nuts to the brake booster and brake pedal assembly. Refer to Exploded View .
  6. Install the Intelligent Key warning buzzer to the strut tower.
  7. Connect the harness connector to the booster pressure sensor.
  8. Install master cylinder assembly. Refer to Removal and Installation .
  9. Connect vacuum hose to brake booster. Refer to Exploded View .
  10. Install the cowl top extension. Refer to Removal and Installation .
  11. Install the clevis pin and snap pin to the brake pedal.
  12. Install the harness clip.
  13. Adjust the brake pedal. Refer to Adjustment .
  14. Install instrument lower panel LH. Refer to Removal and Installation .
  15. Bleed the brake system. Refer to Bleeding Brake System .
  16. Inspect the brake booster. Refer to Inspection .
scientia non olet · About LEMON Manuals