Removal and Installation: Installation

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

Install the breather hose (1) as shown.

Courtesy of NISSAN NORTH AMERICA, INC.

Install the breather hose to the breather tube (3) of the electric controlled coupling (2) all the way to the point shown by the solid arrow (

: Front

Install the breather hose to the breather connector with dimension (A) as shown.

(A)	: 15 mm (0.59 in)

If the breather connector (1) and the breather tube (2) were removed, install them as shown.

Courtesy of NISSAN NORTH AMERICA, INC.
- Install the breather connector to the rear suspension member, facing to the vehicle front.
- Install the breather tube to the coupling cover, facing to the vehicle front.
  CAUTION: Do not reuse the breather connector or the breather tube.
If plugs (1) and (2) were removed, install them as shown.

Courtesy of NISSAN NORTH AMERICA, INC.

: Front
Install the breather to the rear final drive.
CAUTION: Do not press on the breather cap. Press on the breather flange.
When oil leaks while removing rear final drive assembly, check oil level after the installation. Refer to Inspection .
When replacing rear final drive assembly, perform writing unit characteristics. Refer to Description .