LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 583 (Rear Final Drive) >> Unit Disassembly And Assembly >> Disassembly

Unit Disassembly And Assembly: Disassembly

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When replacing rear final drive assembly, perform writing unit characteristics. Refer to Description .
NOTE:
  • When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.
  • Before replacing, servicing, or repairing rear final drive assembly due to vibration and / or noise when making low speed turns, refer to TSB to assist in proper diagnosis.
  1. Remove torsional damper mounting nut, using a flange wrench (1) (commercial service tool).
    GNSJSDIA3056Z-056Courtesy of NISSAN NORTH AMERICA, INC.
  2. Remove torsional damper.
  3. Remove harness bracket.
  4. Remove electric controlled coupling.
  5. Remove wave washer.
  6. Remove front oil seal (1) from final drive assembly, using a oil seal remover.
    GNSJSDIA3057Z-057Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not damage final drive assembly.
  7. Remove drain plug and filler plug, if necessary.
  8. Remove side oil seal (1), using a oil seal remover.
    GNSJSDIA3064Z-064Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not damage final drive assembly and side cover.
  9. Remove stud bolt from side cover, if necessary.
scientia non olet · About LEMON Manuals