LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 583 (Rear Final Drive) >> Removal And Installation >> Side Oil Seal >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install side oil seal (cover side) until it becomes flush with the carrier end, using Tool (A).
    GNSALDIA0308Z-308Courtesy of NISSAN NORTH AMERICA, INC.

    Tool number (A)

    : KV40105740 (--)
    CAUTION:
    • Do not reuse side oil seal.
    • When installing, do not incline side oil seals.
    • Apply rear differential gear oil onto side oil seal lip.
  2. Install side oil seal (carrier side) until it becomes flush with the carrier end, using Tool (A) and Tool (B).
    GNSALDIA0309Z-309Courtesy of NISSAN NORTH AMERICA, INC.

    Tool number (A)

    : ST35325000 (--)

    Tool number (B)

    : KV31103000 (J-38982)
    CAUTION:
    • Do not reuse side oil seal.
    • When installing, do not incline side oil seals.
    • Apply rear differential gear oil onto side oil seal lip.
  3. Install rear drive shaft (LH) or (RH) as necessary. Refer to Removal and Installation .
  4. Check rear differential gear oil level and check for rear differential gear oil leaks. Refer to Inspection .
scientia non olet · About LEMON Manuals