Inspection After Disassembly

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

Shaft

Replace shaft if there is any bending, cracking, or other damage.

Joint Sub-assembly

Make sure there is no rough rotation or unusual axial looseness.
Make sure there is no foreign material inside joint sub-assembly.
Check joint sub-assembly for compression scars, cracks or fractures.
CAUTION: If there are any irregular conditions of joint sub-assembly components, replace the entire joint sub-assembly.

Sliding Joint Housing and Spider Assembly

If roller surface of spider assembly has scratches or wear, replace housing and spider assembly.
NOTE: Housing and spider assembly are components which are used as a set.

Support Bearing

Make sure wheel bearing rolls freely and is free from noise, cracks, pitting or wear.

Damper (if equipped)

Check damper for cracks or wear. Install damper with new damper bands.