Removal and Installation: Installation

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of the removal.

Clean the mating surface of the wheel hub lock nut and wheel hub and bearing assembly.
Clean the mating surface of the drive shaft and wheel hub and bearing assembly.

CAUTION:

Do not use a power tool to tighten the wheel hub lock nut.
Align the marks made on the rotor and front wheel hub during disassembly.
Do not reuse cotter pin.
Do not apply lubricating oil to the mating surfaces.
Do not reuse lower strut nuts.
Do not reuse the wheel hub lock nut.