LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 577 (Engine Lubrication System) >> Removal And Installation >> Oil Cooler >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front wheel and tire (RH) using power tool. Refer to Adjustment .
  2. Remove the front fender protector side cover (RH). Refer to Exploded View .
  3. Drain engine coolant. Refer to Changing Engine Coolant .
    CAUTION: Do not spill engine coolant on the drive belt.
  4. Disconnect water hoses from oil cooler.
  5. Remove the oil filter. Refer to Removal and Installation .
  6. Remove oil cooler.

INSPECTION AFTER REMOVAL 

  1. Check oil cooler for cracks.
  2. Check oil cooler for clogging by blowing through coolant inlet. If necessary, replace oil cooler.

Oil Pressure Relief Valve 

Inspect oil pressure relief valve for movement, cracks and breaks by pushing the ball. If replacement is necessary, remove valve by prying it out with a suitable tool. Install a new valve in place by tapping it.

scientia non olet · About LEMON Manuals