Removal and Installation: Removal
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the back door side finishers (LH/RH). Refer to Removal and Installation .
- Remove the rear spoiler nuts.
- Disconnect the harness connector from high-mounted stop lamp.
- Release the rear washer nozzle tube.
- Release the rear spoiler clips with a suitable tool (A), and then remove the rear spoiler.CAUTION: Apply protective tape (B) to the roof panel and rear spoiler to protect the painted surface from damage.
: Clip
- Remove following parts (if necessary) after removing rear spoiler.
- High-mounted stop lamp
- Rear spoiler side trim covers (LH/RH)
- Rear washer nozzle