Diagnosis Procedure

The tire inflation indicator does not function while inflating a tire when the select lever position is in P-range with the ignition switch ON. Refer to Tire Inflation Indicator Function .

1. LOCATION CHANGE 

   Move the vehicle to another area and repeat the procedure of the tire inflation indicator function. Refer to Tire Inflation Indicator Function .

   Is the function normal?

   YES

   Inspection End.

   NO

   GO TO 2.

2. PERFORM SELF DIAGNOSTIC RESULT 

   With CONSULT

   Perform Self Diagnostic Result.

   Are any DTCs detected?

   YES

   Refer to DTC Index .

   NO

   GO TO 3.

3. CHECK HAZARD WARNING LAMP OPERATION 

   Check hazard warning lamp operation with hazard switch.

   Do the hazard warning lamps operate?

   YES

   GO TO 4.

   NO

   Refer to Diagnosis Procedure .

4. PERFORM SELF DIAGNOSTIC RESULT FOR TCM 

   With CONSULT

   Perform Self Diagnostic Result for TRANSMISSION.

   Are any DTCs detected?

   YES

   Refer to CONSULT Function (RE0F10J).

   NO

   GO TO 5.

5. CHECK HORN OPERATION 

   Check horn operation. Refer to Diagnosis Procedure .

   Is the inspection result normal?

   YES

   GO TO 6.

   NO

   Repair or replace malfunctioning components.

6. PERFORM SELF DIAGNOSTIC RESULT 

   With CONSULT

   1. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes.
   2. Perform Self Diagnostic Result.

   Are any DTCs detected?

   YES

   Refer to DTC Index .

   NO

   Replace BCM. Refer to Removal and Installation .