TPMS Registration With Consult Only
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
With CONSULT
- Adjust the tire pressure for all wheels to match the list below.
Tire position
Tire pressure kPa (kg/cm 2 , psi)
Front LH
240 (2.4, 35)
Front RH
220 (2.2, 32)
Rear RH
200 (2.0, 29)
Rear LH
180 (1.8, 26)
- Turn the ignition switch ON.
- Using CONSULT, select "WORK SUPPORT" in BCM (AIR PRESSURE MONITOR). Then, select "ID REGIST."
- Select "Start" on "ID REGIST" screen.
- Drive the vehicle at a speed greater than 32 km/h (20 MPH) for 3 minutes or more.
- After ID registration for all wheels is complete, press "End" on the CONSULT to finish ID registration.
ID registration position
CONSULT
Front LH
"Yet (red)"
|
"Done (green)"
Front RH
Rear RH
Rear LH
- Adjust the tire pressures for all tires to the recommended value. Refer to Tire Air Pressure .
- Test drive the vehicle to ensure that the TPMS lamp is OFF and no warning messages are present.