DTC Detection Logic

DTC

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition

Possible causes

P2813

SELECT SOLENOID

(Select solenoid)

When any of 1, or 2 is satisfied:

1. When all the following conditions are established three times in 1DC
   1. Precondition
      • DTC other than the applicable DTC is not detected.
      • Throttle position: More than 6.27 deg.
      • Vehicle speed: Less than 3 km/h (1 MPH)
      • CVT fluid temperature: More than 20 deg.C (68 deg.F)
      • Selector lever: Other than P, N
      • Turbine speed when performed N -> D, N (P) -> R: More than 500 rpm
      • TCM power supply voltage: More than 11 V
   2. Detection time
      • N -> D: 0.4 seconds
      • N -> R: 0.3 seconds
      • P -> R: 0.3 seconds
2. When all of the following conditions are satisfied and this state is maintained for 30 seconds:
   1. The counting of time continues while all of the following conditions are satisfied and stops when the conditions become unsatisfied (the count is maintained). When accumulated time reaches 30 seconds (Clutch is judged as engaged and the count is reset.)
      • Selector lever: Other than P, N
      • Vehicle speed: Less than 3 km/h (1 MPH)
      • Differences between primary pulley speed and secondary speed: Less than 120 rpm
      • Clutch instructions pressure: 0.95 MPa or more
      • Differences between turbine speed and input speed: Less than 200 rpm
      • Turbine speed - speed: More than 450 rpm
      • DTC other than the applicable DTC is not detected.
      • TCM power supply voltage: More than 11 V

Select solenoid valve