DTC Confirmation Procedure

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

GO TO 2.

CHECK DTC DETECTION

With CONSULT

Start the engine.
Select "Data Monitor" in "TRANSMISSION".
Select "FLUID TEMP".

Maintain the following conditions for 10 seconds or more.

FLUID TEMP

: More than -20 deg.C (-4 deg.F)

Check the first trip DTC.

With GST

Start the engine and wait for at least 10 seconds.
CAUTION: When the ambient temperature is less than -20 deg.C (-4 deg.F) and the engine is cold, warm up the engine for approximately 5 minutes.
Check the first trip DTC.

Is "P084C"detected?

YES

Go to Diagnosis Procedure .

INSPECTION END