Diagnosis Procedure

With CONSULT

1. Turn ignition switch ON.
2. Select "Self Diagnostic Results" in "METER/M&A".

Is any DTC detected?

YES

Check DTC detected item. Refer to DTC Index .

NO

GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect CVT shift selector connector.
3. Turn ignition switch ON.
4. Check voltage between CVT shift selector harness connector terminal and ground.

   +		-	Condition	Voltage (Approx.)
   CVT shift selector
   Connector	Terminal
   M78	7	Ground	Ignition switch: ON	12 V
   			Ignition switch: OFF	0 V
   	8		Ignition switch: ON	12 V
   			Ignition switch: OFF	0 V
   	9		Ignition switch: ON	12 V
   			Ignition switch: OFF	0 V
   	10		Ignition switch: ON	12 V
   			Ignition switch: OFF	0 V

Is the inspection result normal?

YES

GO TO 3.

NO

GO TO 4.

1. Turn ignition switch OFF.
2. Check manual mode switch. Refer to Component Inspection .

Is the inspection result normal?

YES

GO TO 5.

NO

Repair or replace damaged parts.

1. Turn ignition switch OFF.
2. Check diode.
3. Disconnect combination meter connector.
4. Check continuity between CVT shift selector harness connector terminals and combination meter harness connector terminals.

   CVT shift selector		Combination meter		Continuity
   Connector	Terminal	Connector	Terminal
   M78	7	M23	43	Existed
   	8		45
   	9		44
   	10		46

5. Check continuity between CVT shift selector harness connector terminals and ground.

   CVT shift selector		--	Continuity
   Connector	Terminal
   M78	7	Ground	Not existed
   	8
   	9
   	10

Is the inspection result normal?

YES

Check intermittent incident. Refer to Intermittent Incident .

NO

Repair or replace damaged parts.

Check continuity between CVT shift selector harness connector terminal and ground.

Is the inspection result normal?

YES

Check intermittent incident. Refer to Intermittent Incident .

NO

Repair or replace damaged parts.