DTC Confirmation Procedure

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Be careful of the driving speed.

PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

GO TO 2.

CHECK DTC DETECTION

Start the engine.
Drive the vehicle.

Maintain the following conditions for 10 seconds or more.

Selector lever	: "D" position
Engine speed	: 1, 200 rpm or more
Vehicle speed	: 40 km/h (25 MPH) or more

Stop the vehicle.
Check the first trip DTC.

Is "P0793" detected?

YES

Go to Diagnosis Procedure .

INSPECTION END