LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 568 (Instrument Panel) >> Removal And Installation >> Instrument Panel Assembly >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative and positive battery terminals, then wait at least three minutes. Refer to Removal and Installation .
  2. Using a suitable tool remove instrument side finishers (LH/RH) (1).
    GNSALJIA0335Z-335Courtesy of NISSAN NORTH AMERICA, INC.
    NOTE: LH side shown; RH side similar
  3. Remove front kicking plates (LH/RH). Refer to Removal and Installation - Front Kicking Plate .
  4. Remove front pillar finishers (LH/RH). Refer to Removal and Installation .
  5. Remove combination switch. Refer to Removal and Installation .
  6. Remove instrument lower panel LH. Refer to Removal and Installation .
  7. Remove center console assembly. Refer to Removal and Installation .
  8. Remove combination meter. Refer to Removal and Installation .
  9. Remove AV control unit. Refer to Removal and Installation .
  10. Remove front display unit. Refer to Removal and Installation .
  11. Remove glove box assembly. Refer to Removal and Installation .
  12. Remove instrument panel tweeter grilles (LH/RH) and center speaker grille.
  13. Remove instrument panel bolt (A) from the instrument panel tweeter grille RH area.
    GNSDB121309Courtesy of NISSAN NORTH AMERICA, INC.
  14. Remove front passenger air bag module. Refer to Removal and Installation .
  15. Remove instrument panel assembly screws.
  16. Disconnect the harness connectors from the instrument panel assembly.
  17. Disconnect the antenna cable.
  18. Remove the instrument panel assembly.
scientia non olet · About LEMON Manuals