Work Procedure

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

SAVING VEHICLE SPECIFICATION
CONSULT Configuration

Perform "Before Replace ECU" of "Read / Write Configuration" in "MULTI AV" to save or print current vehicle specification.

NOTE: If "Before Replace ECU" of "Read / Write Configuration" can not be used, use the "Manual Configuration" after replacing NAVI control unit.

GO TO 2.
REPLACE NAVI CONTROL UNIT
Replace NAVI control unit. Refer to Removal and Installation .

GO TO 3.
WRITING VEHICLE SPECIFICATION
CONSULT Configuration

Perform "After Replace ECU" of "Read / Write Configuration" or "Manual Configuration" to write vehicle specification. Refer to Work Procedure .

Work End.