Removal and Installation: Installation
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the rear wiper arm mount as shown, below. This will reduce the possibility of wiper arm looseness.
- Operate the rear wiper motor to move it to the auto stop position.
- Adjust the rear wiper blade position. Refer to Adjustment .
- Install the rear wiper arm and the rear wiper nut.
- Close the rear wiper arm cover.
- Check that the rear wiper blade stops at the specified position.