Extended Storage Switch (If Equipped)
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
The following switch may be mounted on the fuse block (Junction Box) for transportation and storage.
|
|
Extended storage switch |
||||
|
|
Type A |
|
Type B |
|
Type C |
Remove the extended storage switch if it causes the interference when checking fuses.
How To Extended Storage Switch ON/OFF
CAUTION:
- Turn the ignition switch OFF when operating the extended storage switch.
- Under normal conditions, keep the extended storage switch in ON state. Never operate the extended storage switch except when necessary.
- Type A
- To turn the extended storage switch OFF, pull it up in
direction as shown in the figure.
- To turn the extended storage switch ON, press it in
direction as shown in the figure.
- To turn the extended storage switch OFF, pull it up in
- Type B
- To turn the extended storage switch OFF, hold
of the switch and pull up in
direction as shown in the figure.
- To turn the extended storage switch ON, press it in
direction as shown in the figure.
- To turn the extended storage switch OFF, hold
- Type C
- To turn the extended storage switch OFF, pull it up in
direction as shown in the figure.
- To turn the extended storage switch ON, press it in
direction as shown in the figure.
- To turn the extended storage switch OFF, pull it up in
How To Remove Extended Storage Switch
Type A
- Turn the ignition switch OFF.
- Turn the extended storage switch OFF.
- Press pawl
and tilt to disengage the extended storage switch. Press pawl
and tilt to remove the extended storage switch.
CAUTION: Never use fuse for bus bar.NOTE:- Extended storage switch and bus bar are removed together. Remove bus bar from extended storage switch, if necessary.
- Install removed bus bar to fuse block.
- Extended storage switch is for transportation and storage. Reinstallation is not required after the removal.
Type B
- Turn the ignition switch OFF.
- Turn the extended storage switch OFF.
- Hold
and pull up the extended storage switch hard in
direction.
CAUTION: Never use fuse for bus bar.NOTE:- Extended storage switch and bus bar may be removed together. Remove bus bar from extended storage switch, if necessary.
- Install removed bus bar to fuse block.
- Extended storage switch is for transportation and storage. Reinstallation is not required after the removal.
Type C
- Turn the ignition switch OFF.
- Turn the extended storage switch OFF.
- Hold
and pull up the extended storage switch hard in
direction.
CAUTION: Never use fuse for bus bar.NOTE:- Extended storage switch and bus bar are removed together. Remove bus bar from extended storage switch, if necessary.
- Install removed bus bar to fuse block.
- Extended storage switch is for transportation and storage. Reinstallation is not required after the removal.