DTC Diagnosis Procedure

The terminal "2" (L) circuit controls the charge warning lamp. The charge warning lamp illuminates when the ignition switch is set to ON or START. When the generator is providing sufficient voltage with the engine running, the charge warning lamp will go off. If the charge warning lamp illuminates with the engine running, a malfunction is indicated.

1. CHECK "L" TERMINAL CIRCUIT (SHORT) 
   1. Turn ignition switch OFF.
   2. Disconnect generator connector.
   3. Turn ignition switch ON.

   Does charge warning lamp illuminate?

   YES

   GO TO 2.

   NO

   Refer to Work Flow (With DSS-5000P NI) or Work Flow (Without DSS-5000P NI) .

2. CHECK HARNESS CONTINUITY (SHORT CIRCUIT) 
   1. Turn ignition switch OFF.
   2. Disconnect the battery cable from the negative terminal.
   3. Disconnect combination meter connector.
   4. Check continuity between the combination meter harness connector and ground.

      Combination meter		Ground	Continuity
      Connector	Terminal
      M23	30		No

   Is the inspection result normal?

   YES

   Replace the combination meter. Refer to Removal and Installation .

   NO

   Repair or replace the harness or connectors.