DTC Diagnosis Procedure
- CHECK FRONT WASHER MOTOR FUSE
- Turn the ignition switch OFF.
- Check that the following fuse is not blown.
Component
Capacity
Fuse No.
Location
Front washer motor
10 A
1
Fuse block (J/B)
Is the inspection result normal?
YES
GO TO 2.
NO
Replace the fuse after repairing the affected circuit.
- CHECK FRONT WASHER MOTOR POWER SUPPLY
- Disconnect front washer motor.
- Turn ignition switch ON.
- Check voltage between front washer motor harness connector and ground.
Terminals
Washer switch
Voltage
(Approx.)
(+)
(-)
Front washer motor
Ground
Connector
Terminal
E105
1
ON
Battery voltage
OFF
0 V
Is the inspection result normal?
YES
GO TO 3.
NO
GO TO 4.
- CHECK FRONT WASHER MOTOR GROUND CIRCUIT
Check continuity between front washer motor harness connector and ground.
Front washer motor
Ground
Continuity
Connector
Terminal
E105
2
Yes
Is the inspection result normal?
YES
Replace front washer motor. Refer to Washer Tank .
NO
Repair or replace harness.
- CHECK WASHER SWITCH
Check washer switch. Refer to Component Inspection .
Is the inspection result normal?
YES
Repair harness between fuse and front washer motor.
NO
Replace washer switch. Refer to Wiper and Washer Switch .