Diagnosis Procedure
- CHECK FRONT FOG LAMP FUSE
- Turn ignition switch OFF.
- Check that the following fuse is not blown:
Unit
Location
Fuse No.
Capacity
Front fog lamp
IPDM E/R
49
15A
Is the inspection result normal?
YES
GO TO 2 .
NO
Replace the blown fuse after repairing the affected circuit.
- CHECK FRONT FOG LAMP OUTPUT VOLTAGE
CONSULT
- Disconnect front fog lamp connector.
- Turn ignition switch ON.
- Select "EXTERNAL LAMPS" in "Active Test" mode of "IPDM E/R".
- While operating the test items, check the voltage between front fog lamp harness connector and ground.
(+)
(-)
Test item
Voltage
(Approx.)
Front fog lamp
Connector
Terminal
RH
E303
1
Ground
EXTERNAL LAMPS
Fog
Battery voltage
Off
0 V
E306
3
Fog
Battery voltage
Off
0 V
LH
E214
1
Fog
Battery voltage
Off
0 V
E223
3
Fog
Battery voltage
Off
0 V
Is the inspection result normal?
YES
GO TO 5 .
NO
GO TO 3 .
- CHECK FRONT FOG LAMP POWER SUPPLY CIRCUIT (SHORT)
- Disconnect applicable front fog lamp connector and IPDM E/R connector.
- Check continuity between IPDM E/R harness connector and ground.
IPDM E/R
Ground
Continuity
Connector
Terminal
E200
78
No
79
Is the inspection result normal?
YES
GO TO 4 .
NO
Repair or replace harness.
- CHECK FRONT FOG LAMP POWER SUPPLY CIRCUIT (OPEN)
- Turn ignition switch OFF.
- Disconnect IPDM E/R connector.
- Check continuity between IPDM E/R harness connector and front fog lamp harness connector.
Front fog lamp
IPDM E/R
Continuity
Connector
Terminal
Connector
Terminal
RH
E303
1
E200
78
Yes
E306
3
LH
E214
1
79
E223
3
Is the inspection result normal?
YES
Replace IPDM E/R . Refer to Removal and Installation .
NO
Repair or replace harness.
- CHECK FRONT FOG LAMP GROUND CIRCUIT
Check continuity between front fog lamp harness connector and ground.
Front fog lamp
Ground
Continuity
Connector
Terminal
RH
E303
2
Yes
E306
4
LH
E214
2
E223
4
Is the inspection result normal?
YES
Replace bulb. Refer to Bulb Replacement .
NO
Repair or replace harness.