Diagnosis Procedure

1. Turn ignition switch OFF.
2. Check that the following fuse is not blown:

Is the inspection result normal?

YES

GO TO 2

NO

Replace the blown fuse after repairing the affected circuit.

1. Remove daytime running light relay.
2. Check voltage between daytime running light relay harness connector and ground.

   (+)		(-)	Voltage (Approx.)
   Daytime running light relay
   Connector	Terminal
   E222	2	Ground	Battery voltage
   	5

Is the inspection result normal?

YES

GO TO 3

NO

Repair or replace harness.

Check daytime running light relay. Refer to Component Inspection .

Is the inspection result normal?

YES

GO TO 4

NO

Replace daytime running light relay.

CONSULT

1. Install daytime running light relay.
2. Turn ignition switch ON.
3. Select "EXTERNAL LAMPS" in "Active Test" mode of "IPDM E/R".
4. While operating the test item, check voltage between IPDM E/R harness connector and ground.

   (+)		(-)	Test item		Voltage (Approx.)
   IPDM E/R
   Connector	Terminal
   E201	85	Ground	EXTERNAL LAMPS	Hi	0 V
   				Off	Battery voltage

Is the inspection result normal?

YES

Daytime running light relay circuit is OK.

NO

GO TO 5

NO

Replace IPDM E/R. Refer to Removal and Installation .

1. Turn ignition switch OFF.
2. Remove daytime running light relay.
3. Disconnect IPDM E/R harness connector.
4. Check continuity between IPDM E/R harness connector and daytime running light relay harness connector.

   IPDM E/R		Daytime running light relay		Continuity
   Connector	Terminal	Connector	Terminal
   E201	85	E222	1	Yes

Is the inspection result normal?

YES

GO TO 6

NO

Repair or replace harness.

Check continuity between IPDM E/R harness connector and ground.

Is the inspection result normal?

YES

Replace IPDM E/R. Refer to Removal and Installation .

NO

Repair or replace harness.