LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 549 (Audio, Visual & Navigation System (DTC/Circuit Diagnosis)) >> DTC/Circuit Diagnosis >> DTC B1383: INCOMP Steering Angle Sensor Adjust >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. ADJUST NEUTRAL POSITION OF STEERING ANGLE SENSOR 

    Adjusts the steering angle sensor neutral position on ABS actuator and electrical unit (control unit) side. Refer to Work Procedure .

    NOTE: When B1383 is detected, adjust the predictive course line center position of the steering angle sensor.

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE AGAIN 

    Perform DTC confirmation procedure again. Refer to DTC Confirmation Procedure .

    Is DTC B1383 detected again?

    YES

    Replace steering angle sensor. Refer to Removal and Installation

    NO

    Inspection End.

scientia non olet · About LEMON Manuals