Diagnosis Procedure

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.

DETERMINE MALFUNCTION TYPE
With CONSULT
1. Turn ignition switch ON.
2. Turn ignition switch OFF and wait at least 30 seconds.
3. Turn ignition switch ON and wait at least 30 seconds or more.
4. Select "Self Diagnostic Result" mode of "MULTI AV" using CONSULT.
5. Check DTC.
Is DTC B130D detected?

YES

GO TO 2.

YES

GO TO 3.

YES

GO TO 4.

NO

Refer to Intermittent Incident .

CHECK SOUND SIGNAL CIRCUITS FOR OPEN OR SHORT TO GROUND

Turn ignition switch OFF.
Disconnect audio unit connector M50, front door speaker RH connector and front tweeter RH connector.

Check the continuity between audio unit connector M50 and front door speaker RH connector D112.

Audio unit		front door speaker RH		Continuity
Connector	Terminal	Connector	Terminal
M50	11	D112	1	Yes
	12		2

Check the continuity between audio unit connector M50 and front tweeter RH connector M111.

Audio unit		Front tweeter RH		Continuity
Connector	Terminal	Connector	Terminal
M50	11	M111	1	Yes
	12		2

Check the continuity between audio unit connector M50 and ground.

Audio unit		Continuity
Connector	Terminal			Ground
M50	11	--	No
	12

Is the inspection result normal?

YES

Replace front door speaker RH or front tweeter RH. Refer to Removal and Installation (front door speaker) or Removal and Installation (front tweeter).

Repair or replace harness or connectors.

CHECK SOUND SIGNAL CIRCUITS FOR SHORT

Turn ignition switch OFF.
Disconnect audio unit connector M50, front door speaker RH connector and front tweeter RH connector.

Check the continuity between the terminals of audio unit connector M50.

Audio unit			Continuity
Connector	Terminal
M50	11	12	No

Is the inspection result normal?

YES

Replace front door speaker RH or front tweeter RH. Refer to Removal and Installation (front door speaker) or Removal and Installation (front tweeter).

Repair or replace harness or connectors.

CHECK SOUND SIGNAL CIRCUIT FOR SHORT TO POWER SUPPLY

Turn ignition switch OFF.
Disconnect audio unit connector M50, front door speaker RH connector and front tweeter RH connector.
Turn ignition switch ON.

Check the voltage between audio unit connector M50 and ground.

Audio unit		Ground	Voltage
Connector	Terminal
M50	11	--	0 V
	12

Is the inspection result normal?

YES

Replace front door speaker RH or front tweeter RH. Refer to Removal and Installation (front door speaker) or Removal and Installation (front tweeter).

Repair or replace harness or connectors.