DTC Diagnosis Procedure
WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK CONNECTOR
- Turn the ignition switch OFF.
- Disconnect the battery cable from the negative terminal.
- Check the terminals and connectors of the steering angle sensor for damage, bend and loose connection (unit side and connector side).
Is the inspection result normal?
YES
GO TO 2.
NO
Repair the terminal and connector.
- CHECK HARNESS FOR OPEN CIRCUIT
- Disconnect the connector of steering angle sensor.
- Check the resistance between the steering angle sensor harness connector terminals.
Steering angle sensor harness connector
Resistance (Ohm)
Connector No.
Terminal No.
M17
5
2
Approx. 54 - 66
Is the measurement value within the specification?
YES
GO TO 3.
NO
Repair the steering angle sensor branch line.
- CHECK POWER SUPPLY AND GROUND CIRCUIT
Check the power supply and the ground circuit of the steering angle sensor. Refer to Wiring Diagram .
Is the inspection result normal?
YES
Replace the steering angle sensor. Refer to Removal and Installation .
YES
Error was detected in the steering angle sensor branch line.
NO
Repair the power supply and the ground circuit.