DTC Diagnosis Procedure

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Disconnect the following harness connectors.
- ECM
- ABS actuator and electric unit (control unit)
- Harness connectors E5 and F14

Check the continuity between the ABS actuator and electric unit (control unit) harness connector and the harness connector.

ABS actuator and electric unit (control unit) harness connector		Harness connector		Continuity
Connector No.	Terminal No.	Connector No.	Terminal No.
E125	41	E5	5	Existed
	27		15	Existed

Is the inspection result normal?

YES

Check CAN system type decision again.

YES

Error was detected in the main line between the ABS actuator and electric unit (control unit) and the TCM.

Repair the main line between the ABS actuator and electric unit (control unit) and the TCM.