LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 544 (Automatic Transmission (Re7R01B) (2 Of 2)) >> Removal And Installation >> Output Speed Sensor >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD and 2019 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative terminal. Refer to Battery Disconnect .
  2. Remove propeller shaft assembly. Refer to Removal and Installation .
  3. Remove rear cross member (1) and rear engine mount insulator (2).
    GNSALDIA0835Z-835Courtesy of NISSAN NORTH AMERICA, INC.
  4. Drain ATF through drain plug. Refer to Changing .
  5. Remove clips (1).
    GNSAWDIA1458Z-458Courtesy of NISSAN NORTH AMERICA, INC.
  6. Remove oil pan bolts (A), oil pan (2) and oil pan gasket.

    SYMBOL

    : Front

    (A)

    : Oil pan bolt
  7. Support A/T assembly with a suitable jack.
    CAUTION: When setting suitable jack, be careful to prevent damage to control valve & TCM and A/T assembly.
  8. Remove bolts (A) and (B) for adapter case and A/T assembly.
    GNSJSDIA1845Z-845Courtesy of NISSAN NORTH AMERICA, INC.

    (1)

    : Bracket

    (A)

    : Bolt

    (B)

    : Self-sealing bolt
  9. Tap adapter case using suitable tool (A).
    GNSJPDIA0027Z-027Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Be careful not to damage adapter case.
  10. Remove adapter case (with needle bearing) from A/T assembly.
    G04075691Courtesy of NISSAN NORTH AMERICA, INC.
  11. Disconnect the harness connector (A) from the output speed sensor.
    GNSAWDIA1459Z-459Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Be careful not to damage connector
  12. Disengage terminal clips (1).
  13. Remove bolt (A) output speed sensor (1) from A/T assembly.
    GNSAWDIA1460Z-460Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:
    • Do not subject it to impact by dropping or hitting it.
    • Do not disassemble.
    • Do not allow metal filings, etc. to get on the sensor's front edge magnetic area.
    • Do not place in an area affected by magnetism.
scientia non olet · About LEMON Manuals