Removal and Installation: Installation

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD and 2019 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order removal.

CAUTION:

Insert the tip of parking rod between the parking pole and the parking actuator support when assembling the adapter case.
Do not reuse drain plug gasket.

Refer to the following when installing output speed sensor.
CAUTION:
- Do not subject it to impact by dropping or hitting it.
- Do not disassemble.
- Do not allow metal filings, etc. to get on the sensor's front edge magnetic area.
- Do not place in an area affected by magnetism.

Refer to the following when installing adapter case.

Apply recommended sealant (Genuine Anaerobic Liquid Gasket or equivalent) to adapter case as shown. Refer to Recommended Chemical Products and Sealants .

Courtesy of NISSAN NORTH AMERICA, INC.

Sealant starting point and end-point (A)	: Start and finish point shall be in the center of two bolts.
Overlap width of sealant starting point and end-point (B)	: 3 - 5 mm (0.12 - 0.20 in)
Sealant width (C)	: 1.0 - 2.0 mm (0.04 - 0.08 in)
Sealant height (C)	: 0.4 - 1.0 mm (0.016 - 0.04 in)

CAUTION: Completely remove all moisture, oil and old sealant, etc. from A/T assembly and rear extension assembly mounting surfaces.

Tighten adapter case bolts (A) and (B) to the specified torque.

Courtesy of NISSAN NORTH AMERICA, INC.

(1)	: Bracket
(A)	: Bolt
(B)	: Self-sealing bolt

Refer to the following when installing oil pan (2) (with oil pan gasket) and clips (1) to A/T assembly.

Courtesy of NISSAN NORTH AMERICA, INC.

	: Front
(A)	: Oil pan bolt

CAUTION:

Do not reuse oil pan gasket and oil pan mounting bolts.
Install oil pan gasket in the direction to align hole position.
Install it so that drain plug comes to the position as shown in the figure.
Be careful not to pinch harnesses.
Completely remove all moisture, oil and old gasket, etc. from oil pan mounting surface.

Tighten oil pan mounting bolts to the specified torque in sequence shown after temporarily tightening them. Tighten necessary oil pan mounting bolts with specified torque.

Courtesy of NISSAN NORTH AMERICA, INC.

: Front

Fill with ATF after installation. Refer to Changing .