Front Wiper Arm Adjustment

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.

Operate wiper motor one full cycle, then turn "OFF" (Auto Stop).

Lift the wiper blade up and then rest it onto glass surface, check the blade clearance (A), (B), (C) and (D).

Courtesy of NISSAN NORTH AMERICA, INC.

(1): Molding end

Clearance (A)	: 43.0 +/- 7.5 mm (1.69 +/- 0.30 in)
Clearance (B)	: 39.4 +/- 7.5 mm (1.55 +/- 0.30 in)
Clearance (C)	: 30.0 +/- 7.5 mm (1.18 +/- 0.30 in)
Clearance (D)	: 60.0 +/- 7.5 mm (2.36 +/- 0.30 in)

Remove wiper arm covers and wiper arm nuts.
Adjust front wiper arms on wiper motor pivot shafts to obtain above specified blade clearances.
Tighten wiper arm nuts to specified torque, and install wiper arm covers.