Cargo Van
WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK BATTERY SAVER OUTPUT/POWER SUPPLY CIRCUIT
- Turn ignition switch ON.
- Check voltage between BCM harness connector M20 terminal 56 and ground.
(+)
(-)
Voltage (V) (Approx.)
Connector
Terminal
M20
56
Ground
Battery voltage
Is the inspection result normal?
YES
GO TO 2
NO
Replace BCM after making sure battery saver output/power supply circuit is not shorted to ground. Refer to Removal and Installation .
- CHECK BATTERY SAVER OUTPUT/POWER SUPPLY OPEN CIRCUIT
- Turn ignition switch OFF.
- Disconnect the following harness connectors.
- BCM M20
- Front room/map lamp assembly R25
- Front cargo lamp R26 (if equipped)
- Center cargo lamp R27 (if equipped)
- Rear cargo lamp R28
- Check continuity between BCM harness connector M20 terminal 56 and each interior room lamp harness connector terminal 1.
BCM
Each interior room lamp
Continuity
Connector
Terminal
Connector
Terminal
M20
56
Front room/map lamp assembly
R25
1
Yes
Front cargo lamp
R26
1
Center cargo lamp
R27
1
Rear cargo lamp
R28
1
Is the inspection result normal?
YES
GO TO 3
NO
Repair the harness or connectors.
- CHECK BATTERY SAVER OUTPUT/POWER SUPPLY SHORT CIRCUIT
Check continuity between BCM harness connector M20 terminal 56 and ground.
Connector
Terminal
--
Continuity
M20
56
Ground
No
Is the inspection result normal?
YES
Check that each interior room lamp has no internal short circuit.
NO
Repair the harness or connectors.