LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 531 (Seats) >> Unit Disassembly And Assembly >> Front Seat >> Disassembly and Assembly >> Seatback Cushion - Driver Power Seat

Seatback Cushion - Driver Power Seat

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.

Disassembly 

  1. Unzip the rear cover.
  2. Remove the armrest, (if equipped).
    1. Remove the armrest bolt cover.
    2. Remove the armrest bolt and armrest.
  3. Remove the headrest.
  4. Release the headrest holder locks and remove the headrest holders.
    G04146145Courtesy of NISSAN NORTH AMERICA, INC.
  5. Remove the seatback cushion and seatback cushion trim.
  6. Remove the four bolts and seatback frame.
  7. Remove the lumbar assembly.
    1. Remove the four lumbar assembly bolts.
    2. Disconnect the cable from the actuator.
    3. Disconnect the cable retainers on the lower frame.
    4. Remove the lumbar and cable assembly.
  8. Separate the seatback trim from the seatback cushion.
    1. Pull seat cushion trim upward to release velcro strips.
    2. Remove four center hog rings.
    3. Pull the seat cushion trim up on the RH side and remove the hog rings.
    4. Pull the seat cushion trim up on the LH side and remove the hog rings.
    5. Remove the hog rings along seat cushion trim top.

Assembly 

Assembly is in the reverse order of disassembly.

CAUTION:
  • Make sure to identify and position the front side air bag module pocket in the seatback pad during assembly.
  • If a malfunction was detected by the air bag warning lamp, after repair or replacement of the malfunction parts, reset the memory using self-diagnosis or CONSULT.
  • After work is completed, check that no system malfunction is detected by air bag warning lamp.
  • Always install new side air bag module attaching nuts.
  • Always route side air bag module harness in original location. Replace any deformed or damaged clips with same type and color. Always install clips in the original location in the harness.
  • Smooth out all wrinkles during assembly.
  • Inspect seatback foam pad, seatback cover and seatback cover chutes. Replace if damaged.
  • Replace any deformed or damaged parts.
  • Do not reuse hog rings. Ensure any old hog ring pieces are removed from the seat.
  • Use only one hog ring in each designated location.
  • Make sure hog rings are correctly fastened around both the seatback cover and pad wires.
NOTE: Use NISSAN standard hog rings and tools to assemble.
scientia non olet · About LEMON Manuals