LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 531 (Seats) >> Unit Disassembly And Assembly >> Fourth Row Seats >> Disassembly and Assembly - RH Bench Seat >> Seatback

Disassembly and Assembly - RH Bench Seat: Seatback

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.

Disassembly 

  1. Remove the fourth row seat RH. Refer to Removal and Installation .
  2. Remove seat belt buckle and seat belt retractor anchor bolt. Refer to Removal and Installation .
  3. Press the headrest holder lock button in, then remove the headrest. Repeat for second headrest on seat assembly.
    GNSALJIA0743Z-743Courtesy of NISSAN NORTH AMERICA, INC.
  4. Remove the seat belt escutcheon.
    1. Remove the (two for inner, two for outer) escutcheon screws from the seatback.
    2. Thread each seat belt through the slot in the escutcheon to remove.
  5. Release the two J-clip retainers (A) at the lower edge and unzip the sliders from the LH/RH zippers (B).
    GNSDB114924Courtesy of NISSAN NORTH AMERICA, INC.
  6. From the inside of the seatback, squeeze the headrest holder tabs at the base of the stay pipe and pull up to remove.
    G04146145Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Before installing headrest holder, check its orientation.

    (front/rear and right/left)

  7. Release the five remaining J-clips that wrap around the bottom of seatback as shown.
  8. Remove the seatback trim.
    1. Carefully lift the seatback trim and cushion up as an assembly from the seat frame.
    2. Thread the seat belt assembly through the opening in the trim.
    3. Release the seatback stiffener from the upper seatback frame edge.
  9. Remove the hog rings and separate the seatback trim and seatback pad.
    NOTE: Remove all pieces of hog rings and discard them.

Assembly 

Assembly is in the reverse order of disassembly.

NOTE:
  • Install new hog rings on the seat trim in their original positions.
    GNSALJIA0746Z-746Courtesy of NISSAN NORTH AMERICA, INC.

    SYMBOL : Hog rings

  • Use only one hog ring in each designated location.
  • Be sure hook fastener (A) is pressed into place after seatback trim is assembled.
CAUTION:
  • Make sure hog rings are correctly fastened around both the seat trim and pad wires.
  • Replace any deformed or damaged hog rings.
  • Make sure any old hog ring pieces are removed from seat.
  • Before installing headrest, check its orientation and be sure it is correct (A); avoid incorrect (B).
    GNSALJIA0747Z-747Courtesy of NISSAN NORTH AMERICA, INC.
  • After installing headrest (A), pull it all the way up and be sure it does not disengage from the seatback.
scientia non olet · About LEMON Manuals