LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 531 (Seats) >> Removal And Installation >> Front Seat >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Do not leave any objects (screwdrivers, tools, etc.) on the seat during seat back repair. It can lead to personal injury if the side air bag module should accidentally deploy.
CAUTION:
  • When removing or installing the seat trim, handle it carefully to keep dirt out and avoid damage.
  • Before removing the front seat, turn the ignition switch OFF, disconnect both battery cables and wait at least three minutes.
  • When checking the power seat circuit for continuity using a circuit tester, do not confuse its connector with the side air bag module connector. Such an error may cause the air bag module to deploy.
  • Do not drop, tilt, or bump the side air bag module while installing the seat. Always handle it with care.
  • After front side air bag module inflates, the front seat back assembly must be replaced.
  • When removing and installing the seat, use shop cloths to protect the vehicle from damage.
  1. Disconnect the negative and positive battery terminals and wait at least three minutes. Refer to Battery Disconnect .
  2. Disconnect the harness connector from side air bag module.
  3. Remove the floor trim kicking plate (if equipped). Refer to Removal and Installation - Passenger Van .
  4. Remove the slide covers (if equipped) and front seat bolts.
  5. Disconnect the following seat harness connectors:
    • Seat belt
    • Seat heater (if equipped)
    • Power seat switch (if equipped)
  6. Remove the seat from the vehicle.
scientia non olet · About LEMON Manuals