DTC Diagnosis Procedure

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD and 2019 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

CHECK TCM INPUT SIGNAL

Turn ignition switch ON.
Select "TOW MODE SWITCH" in "Data Monitor" in "TRANSMISSION".

Check the ON/OFF operations of each monitor item.

Monitor Item	Condition	Status
TOW MODE SWITCH	TOW mode switch: Pushed	ON
TOW MODE SWITCH	Other than the above	OFF

Is the inspection result normal?

YES

Check intermittent incident. Refer to Intermittent Incident .

GO TO 2.

CHECK CIRCUIT BETWEEN COMBINATION METER AND A/T SHIFT SELECTOR

Turn ignition switch OFF.
Disconnect combination meter connector and A/T shift selector connector.

Check continuity between A/T shift selector harness connector terminals and combination meter harness connector terminals.

A/T shift selector		Combination meter		Continuity
Connector	Terminal	Connector	Terminal	Continuity
M68	6	M24	10	Existed

Is the inspection result normal?

YES

GO TO 3.

Repair or replace malfunctioning parts.

CHECK CIRCUIT BETWEEN COMBINATION METER AND A/T SHIFT SELECTOR

Check continuity between combination meter harness connector terminals and ground.

Combination meter		--	Continuity
Connector	Terminal
M24	10	Ground	Not existed

Is the inspection result normal?

YES

GO TO 4.

Repair or replace malfunctioning parts.

CHECK A/T SHIFT SELECTOR GROUND CIRCUIT

Check continuity between A/T shift selector connector harness connector terminals and ground.

A/T shift selector		--	Continuity
Connector	Terminal
M68	2	Ground	Existed

Is the inspection result normal?

YES

GO TO 5.

Repair or replace malfunctioning parts.

CHECK COMBINATION METER
Check combination meter. Refer to Work Flow .

Is the inspection result normal?

YES

Replace the A/T shift selector. Refer to Removal and Installation .

NO

Replace the combination meter. Refer to Removal and Installation .