DTC Confirmation Procedure
WARNING: This page is about a different car, the 2019 Nissan NV3500 HD and 2019 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- " DTC Diagnosis Procedure " must be performed before starting "DTC CONFIRMATION PROCEDURE".
- Never perform "DTC CONFIRMATION PROCEDURE" before completing the repair, which may cause secondary malfunction.
- Always drive vehicle at a safe speed.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
GO TO 2.
- CHECK DTC DETECTION
With CONSULT
- Start the engine.
- Select "SLCT LVR POSI" and "GEAR" in "Data Monitor" in "TRANSMISSION".
- Drive vehicle the following condition. (Maintain the each gear for 6 seconds or more.)
ATF TEMP 1
: 20 deg.C (68 deg.F) or more
MANU MODE SW
: ON
GEAR
: 1st -> 2nd -> 3rd -> 4th -> 5th -> 6th -> 7th
VHCL/S SE-A/T
: 12 km/h (7 MPH) or more
- Perform "Self Diagnostic Results" in "TRANSMISSION".
With GST
Follow the procedure "With CONSULT".
Is "P0893" detected?
YES
Go to DTC Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END