DTC Confirmation Procedure

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD and 2019 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Always drive vehicle at a safe speed.

PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

GO TO 2.

CHECK DTC DETECTION

With CONSULT

Turn ignition switch ON.
Select "VHCL/S SE-A/T" in "Data Monitor" in "TRANSMISSION".

Start the engine and maintain the following condition for 10 seconds or more.

VHCL/S SE-A/T

: 10 km/h (7 MPH) or more

With GST

Follow the procedure "With CONSULT".

Is "P0713" detected?

YES

Go to DTC Diagnosis Procedure .

To check malfunction symptom before repair: Refer to Intermittent Incident .

Confirmation after repair: INSPECTION END