DTC Confirmation Procedure
WARNING: This page is about a different car, the 2019 Nissan NV3500 HD and 2019 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
GO TO 2.
- CHECK DTC DETECTION
With CONSULT
- Start the engine.
- Select "ACCELE POSI" and "VHCL/S SE-A/T" in "Data Monitor" in "TRANSMISSION".
- Shift the selector lever throughout the entire shift position from "P" to "D". (Hold the selector lever at each position for 2 seconds or more)
- Drive vehicle and maintain the following conditions for 2 seconds or more.
ACCELE POSI
: More than 1.0/8
VHCL/S SE-A/T
: 10 km/h (7 MPH) or more
- Perform "Self Diagnostic Results" in "TRANSMISSION".
With GST
Follow the procedure "With CONSULT".
Is "P0705" detected?
YES
Go to Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END