DTC Diagnosis Procedure
WARNING: This page is about a different car, the 2019 Nissan NV3500 HD and 2019 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK TCM POWER SOURCE
- Turn ignition switch OFF.
- Disconnect A/T assembly connector.
- Check voltage between A/T assembly harness connector terminal and ground.
+
-
Condition
Voltage (Approx.)
A/T assembly
Connector
Terminal
F55
2
Ground
Always
Battery voltage
Is the inspection result normal?
YES
INSPECTION END
NO
GO TO 2.
- DETECT MALFUNCTIONING ITEM
Check the following.
- Open circuit or short circuit in harness between battery positive terminal and A/T assembly harness connector terminal 2.
- Battery
- 10A fuse (No. 30).
Is the inspection result normal?
YES
Check intermittent incident. Refer to Intermittent Incident .
NO
Repair or replace damaged parts.