LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 519 (Steering System) >> Removal And Installation >> Power Steering Oil Pump >> Removal and Installation - VQ40DE >> Removal

Removal and Installation - VQ40DE: Removal

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the power steering fluid from the power steering reservoir tank.
  2. Remove the drive belt. Refer to Removal and Installation .
  3. Remove the right front fender protector. Refer to Removal and Installation .
  4. Disconnect the power steering suction hose from the power steering pump.
  5. Disconnect the power steering oil pressure sensor harness connector.
  6. Remove the eye bolt and disconnect the power steering pressure line from the power steering pump. Plug the lines and discard the copper sealing washers.
    CAUTION: Do not reuse copper sealing washers.
  7. Remove the bolts and the power steering pump from the vehicle.
scientia non olet · About LEMON Manuals