Removal and Installation: Installation
WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
Installation is in the reverse order of removal.
CAUTION:
- Do not turn the ignition switch ON before the completion of the installation procedure.
- Be careful not to damage hydraulic booster assembly stud bolt threads. If hydraulic booster assembly is tilted during installation, the dash panel may damage the threads.
- Perform adjustment before installation. Refer to Inspection and Adjustment .
- Do not reuse a hydraulic booster assembly after an excessive impact. (Slight impulse caused during installation work is acceptable.)
- Always hold the spacer block and front part of ABS actuator and electric unit (control unit) (A) when removing the hydraulic booster assembly.
- Do not deform or bend the brake tubes when installing the hydraulic booster assembly.
- Always use a new gasket between the hydraulic booster assembly, spacer and the dash panel.
- Replace the clevis pin if it is damaged. Refer to Inspection and Adjustment .
- Bleed the brake system. Refer to Bleeding Brake System .
- Perform the brake pedal adjustment after installing the brake pedal assembly and hydraulic booster assembly. Refer to Inspection and Adjustment .
- Perform inspection after installation. Refer to Inspection and Adjustment .