LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 518 (Brake System) >> Removal And Installation >> Brake Piping >> Rear >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • If brake fluid contacts the brake caliper assembly and disc rotor, quickly wipe it off.
  • Do not spill or splash brake fluid on painted surfaces. Brake fluid may seriously damage paint. Wipe it off immediately and wash with water if it gets on a painted surface.
  • Do not depress the brake pedal while brake lines or hoses are disconnected.
  1. Assemble the union bolt (A) and the copper sealing washers (1) to the brake hose.
    GNSAWFIA0795Z-795Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not reuse the copper sealing washers.
  2. Align the brake hose pin to the projection of the brake caliper assembly and tighten the union bolt (A) to the specified torque.
  3. Install the brake tube to the brake hose, temporarily tighten the flare nut by hand until it does not rotate further, and secure the brake hose to the bracket with the lock plate.
    CAUTION: Check that all brake hose or brake tube are not twisted and bent.
  4. Tighten the flare nut to the specified torque with a crowfoot and torque wrench.
    CAUTION: Do not scratch the flare nut and the brake tube.
  5. Bleed the brake system. Refer to Bleeding Brake System .
  6. Install the wheel and tire assembly. Refer to Adjustment .
  7. Perform inspection after installation. Refer to Inspection .
scientia non olet · About LEMON Manuals