LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 516 (Rear Axle) >> Unit Removal And Installation >> Axle Shaft >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire assembly using power tool. Refer to Adjustment .
  2. Remove the wheel sensor from the axle housing. Refer to Exploded View .
  3. Remove the caliper torque member bolts using power tool, leaving brake hose attached, reposition the caliper with wire. Refer to Removal and Installation of Brake Caliper Assembly and Rotor .
  4. Put alignment marks on disc rotor and wheel hub and bearing assembly, then remove the disc rotor.
    CAUTION:
    • Put alignment marks on wheel hub and bearing assembly and disc rotor before removing disc rotor.
    • Do not drop the disc rotor.
  5. Disconnect the park brake cable from the lever. Refer to Exploded View .
  6. Remove the axle nuts.
  7. Remove the axle shaft assembly. Discard the O-ring and seal.
    CAUTION:
    • Do not reuse O-ring.
    • Do not reuse seal.
scientia non olet · About LEMON Manuals