DTC Diagnosis Procedure

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.

Activate and display TPMS sensor IDs
Display tire pressure reported by the TPMS sensor
Read TPMS DTCs
Register TPMS sensor IDs

CHECK LOW TIRE PRESSURE WARNING CONTROL UNIT POWER SUPPLY AND GROUND CIRCUIT
Perform the trouble diagnosis for power supply and ground circuit. Refer to Diagnosis Procedure .

Is the inspection result normal?

YES

GO TO 2.

NO

Repair or replace malfunctioning components.

CHECK TIRE PRESSURE RECEIVER CIRCUIT

Disconnect the tire pressure receiver connector.

Check the continuity between the low tire pressure warning control unit connector and tire pressure receiver connector.

Low tire pressure warning control unit		Tire pressure receiver		Continuity
Connector	Terminal	Connector	Terminal	Continuity
M90	6	E43 (Front LH)	3	Yes
	22		2
	10		1
	26		4
	5	E60 (Front RH)	3
	21		2
	9		1
	25		4
	4	C109 (Rear LH)	3
	20		2
	8		1
	24		4
	3	C110 (Rear RH)	3
	19		2
	7		1
	23		4

Check the continuity between the low tire pressure warning control unit connector and ground.

Low tire pressure warning control unit		--	Continuity
Connector	Terminal	--	Continuity
M90	6	Ground	No
	22
	10
	26
	5
	21
	9
	25
	4
	20
	8
	24
	3
	19
	7
	23

Is the inspection result normal?

YES

GO TO 3.

Repair or replace the malfunctioning harness or connector.

PERFORM SELF DIAGNOSTIC RESULT AGAIN
With CONSULT
1. Check the tire pressure for all wheels and adjust to the specified value. Refer to Tire .
2. Perform tire pressure sensor ID registration for all wheels. Refer to Work Procedure .
3. Perform "Self Diagnostic Result".
Is DTC "C1754" detected?

YES

Replace the low tire pressure warning control unit. Refer to Removal and Installation .

NO

Check for looseness or damage at the harness connector pins of the low tire pressure warning control unit. Repair or replace if necessary.