Diagnosis Procedure
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK BLIND SPOT WARNING INDICATOR CIRCUIT FOR OPEN (1)
- Turn ignition switch OFF.
- Disconnect side radar harness connector and Blind Spot Warning indicator harness connector.
- Check continuity between side radar harness connector and Blind Spot Warning indicator harness connector.
Side radar
Blind Spot Warning indicator
Continuity
Connector
Terminal
Connector
Terminal
B77 LH
4
D21 LH
1
Yes
B78 RH
D116 RH
Is the inspection result normal?
YES
GO TO 2 .
NO
Repair or replace harness or connector.
- CHECK BLIND SPOT WARNING INDICATOR CIRCUIT FOR OPEN (2)
Check continuity between Blind Spot Warning indicator harness connector and ground.
Blind Spot Warning indicator
Ground
Continuity
Connector
Terminal
D21 LH
4
Yes
D116 RH
Is the inspection result normal?
YES
GO TO 3 .
NO
Repair or replace harness or connector.
- CHECK SIDE RADAR VOLTAGE OUTPUT
- Connect side radar harness connector.
- Check voltage between Blind Spot Warning indicator harness connector and ground.
Blind Spot Warning indicator
Ground
Condition
Voltage
(Approx.)
Connector
Terminal
D21 LH
1
Ignition switch
OFF → ON
(Approx. 2 sec.)
6 V
D116 RH
Is the inspection result normal?
YES
Replace Blind Spot Warning indicator. Refer to Removal and Installation .
NO
Replace side radar. Refer to Removal and Installation .