Meter, Warning Lamp & Indicator (DTC/Circuit Diagnosis)

1. Turn ignition switch OFF.
2. Check combination meter and fuel level sensor unit terminals (meter-side and harness-side) for poor connection.

Is the inspection result normal?

YES

GO TO 2.

NO

Repair or replace terminals or connectors.

1. Disconnect combination meter connector and fuel level sensor unit connector.
2. Check continuity between combination meter harness connector and fuel level sensor unit and fuel pump harness connector.

   Connector	Terminal	Connector	Terminal	Continuity
   C5 (with VQ40DE) C37 (with VK56VD)	2	M24	12	Yes

3. Check continuity between fuel level sensor unit and fuel pump harness connector and ground.

   Connector	Terminal	Ground	Continuity
   C5 (with VQ40DE) C37 (with VK56VD)	2		No

Is the inspection result normal?

YES

GO TO 3.

NO

Repair harness or connector.

1. Check continuity between combination meter harness connector and fuel level sensor unit and fuel pump harness connector.

   Connector	Terminal	Connector	Terminal	Continuity
   C5 (with VQ40DE) C37 (with VK56VD)	5	M24	24	Yes

2. Check continuity between fuel level sensor unit and fuel pump harness connector and ground.

   Connector	Terminal	Ground	Continuity
   C5 (with VQ40DE) C37 (with VK56VD)	5		No

Is the inspection result normal?

YES

GO TO 4.

NO

Repair harness or connector.

Check fuel level sensor unit installation, and check whether the float arm interferes or binds with any of the internal components in the fuel tank.

Is the inspection result normal?

YES

Inspection End.

NO

Install the fuel level sensor unit properly.