LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 503 (Engine Mechanical (4.0L)) >> Removal And Installation >> Oil Seal >> Removal and Installation of Front Oil Seal >> Removal

Removal and Installation of Front Oil Seal: Removal

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove front under cover using power tool. Refer to Removal and Installation .
  2. Remove air cleaner and resonator assembly. Refer to Removal and Installation .
  3. Remove drive belt. Refer to Removal and Installation .
  4. Remove engine cooling fan assembly (crankshaft driven). Refer to Removal and Installation (Crankshaft driven type) .
  5. Remove crankshaft pulley as follows:
    1. Remove rear cover plate and install Ring Gear Stopper Tool.

      Tool number

      : -- (J-48761)
    2. Loosen crankshaft pulley bolt so that there is a 10 mm (0.39 in) gap between bolt and crankshaft pulley.
      G04146613Courtesy of NISSAN NORTH AMERICA, INC.
      CAUTION: Do not remove crankshaft pulley bolt. Keep loosened crankshaft pulley bolt in place to protect the crankshaft pulley from dropping.
    3. Pull crankshaft pulley with both hands to remove it.
  6. Remove front oil seal using suitable tool.
    G04132291Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Be careful not to damage front timing chain case or crankshaft.
scientia non olet · About LEMON Manuals