Liquid Gasket Application Procedure
WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the old liquid gasket from the gasket application surface and the mating surface using suitable tool.
- Remove the liquid gasket completely from the groove of the liquid gasket application surface, bolts, and bolt holes.
- Thoroughly clean the mating surfaces and remove moisture, grease and foreign material.
- Attach the liquid gasket tube to the suitable tool.CAUTION: Use Genuine RTV Silicone Sealant or equivalent. Refer to Recommended Chemical Products and Sealants .
- Apply the liquid gasket without breaks to the specified location with the specified dimensions.
- If there is a groove for the liquid gasket application, apply the liquid gasket to the groove.
- Normally apply the liquid gasket on the inside edge of the bolt holes. Also apply to the outside edge of the bolt holes when specified in the procedure.
- Within five minutes of liquid gasket application, install the mating component.
- If the liquid gasket protrudes, wipe it off immediately.
- Do not retighten bolts after the installation.
- Wait 30 minutes or more after installation before refilling the engine with oil or coolant.
- If there is a groove for the liquid gasket application, apply the liquid gasket to the groove.
CAUTION:
If there are more specific instructions in the procedures contained in this information concerning liquid gasket application, observe them.