Component Inspection

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.

CHECK THROTTLE POSITION SENSOR

Turn ignition switch OFF.
Reconnect all harness connectors disconnected.
Perform " Throttle Valve Closed Position Learning". Refer to Description .
Turn ignition switch ON.
Set selector lever to D position.

Check the voltage between ECM harness connector terminals as per the following conditions.

ECM				Condition		Voltage
Connector	+	Connector	-
	Terminal		Terminal
F77	71	F77	75	Accelerator pedal	Fully released	More than 0.36V
					Fully depressed	Less than 4.75V
	72				Fully released	Less than 4.75V
					Fully depressed	More than 0.36V

Is the inspection result normal?

YES

INSPECTION END

Replace electric throttle control actuator. Refer to Removal and Installation .